If you're looking for the Powersharp system from Oregon online then you need to know a little more about it first. Does it really work? Does it cut as well as standard chain? And of course you need to know where you can get the best deal too.
Oregon is the biggest supplier of original equipment chainsaw chains to chainsaw manufacturers. Their latest innovation is a new type of chain that can be sharpened anywhere in seconds with a special sharpener that clips on the end of the chainsaw bar. The Powersharp system completely frees the average user from the need for conventional chainsaw sharpeners, filing or professional sharpening services.
Traditional chainsaw chain must be carefully sharpened to maintain it's cutting performance. Chains gradually become dull with use until performance is greatly reduced and the saw becomes difficult or even dangerous to use. If you hit a rock or metal or run your saw into the ground the chains will get blunt much faster! Annoying if your saw was just sharpened. To sharpen the chain each cutter must be sharpened individually. A file or grinder must be applied at the right angle. A time consuming process that calls for the right tools and a little technique. This can be quite a task for the occasional chain saw user and even old hands often find the need for sharpening inconvenient.
The Powersharp system completely overcomes the problems the average user has with keeping his chain saw sharp.And it really works. It is composed of 3 parts. The special, redesigned Powersharp chain, the chain bar and the Powersharp sharpening unit. The bar and Powersharp unit only needs to be purchased once. Replacement chains are available separately come packaged with a replacement grinding stone for the sharpening unit. In use the Powersharp chain performs well when compared with the equivalent standard chain. In fact in tests the Powersharp chain was found to be slightly faster than standard chain. As well as the high work rate Powersharp chain seems to last longer before it needs re-sharpening. When it does inevitably get blunt the sharpening process is really simple.
All you need to do is fit the Powersharp unit over the end of the chainsaw bar. This is easy even with thick gloves on. There are two alignment pins which go through special holes in the end of powesharp bar to align everything up. Snap the unit shut, start the saw and rev up to full speed. Now the sharpening process only takes 3 or 4 seconds on average and all you need is push the saw and sharpening unit against a solid object. A handy tree stump will do nicely. A few sparks fly and thats it. Turn off the motor, release the sharpening unit and you ready to cut again with a freshly sharpened saw.
Now where can you find the Powersharp Starter System for the best price online?
You can either spend a long time checking dozens of websites. Or you can let someone else do the work for you. I've left a link below to a special site where the research has been done for you.
| Price : $249.99
